SMT PCB handling equipment Buffer Conveyor For 1.2M LED Tube Cooling

1.2 M LED Tube Cooling Buffer Smt Long Board Buffer Conveyor

Technical Parameters HR-1200CB:

Function :This machine controls the PCB first-in, first-out, or last-in first-out function.

1. Dimensions: (L) 1600x (W) 1950x (H) 1700 + 20 / -20mm

2. Product size: PCB board size 50*50～450*1200mm

3. Transfer direction: left-right or right-left, switchable

4. Transmission height: 920+30/-20mm, foot cup adjustment height

5. Transmission speed: adjustable from 0-180 mm/sec

6. Cooling time: less than or equal to ≤ 5~8 minutes, temperature within 50 degrees

(depending on the working environment)

7. Storage mode adjustment: manual adjustment

8. Storage operation mode: diversified optional, can be optimized (first in, first out,

Straight-through, layered interval , etc., with memory function can manually modify the stored data)

9. Storage structure: not easy to deform, no wear up and down, left and right width consistent without bell mouth

10. Storage drive mode: servo motor (220~380V) drive.

11. Track adjustment mode: manual adjustment

12. Transportation structure: single-layer shared linkage: the two-track cylinders should be pushed synchronously .

13. Transportation mode: Storage time can be set, single-layer shared linkage or linkage

14. Transmission motor: 200V, 50~60HZ, 25W motor

15. Cooling device: PLC control air curtain, can be equipped with other auxiliary equipment with fast cooling speed, cooling time ≤ 5~8 minutes

16. Circuit control: the cooling device and the equipment are separated by safety devices and switch control.

The input circuit also has a safety device, and the current exceeding the standard can automatically power off without affecting the power supply of other devices in the line .

17. Control system: PLC touch panel control .

18. Monitoring system: blocking alarm interception

19. Fool-proofing safety: The protective device of the machine meets the requirements of safe production and Fool-proofing,and the emergency stop switch.

Security door: The machine cannot be started after the door is opened. After the door is closed, the electromagnetic lock cannot be opened manually.

20. Software foolproof: Software parameter setting, increase the upper and lower limit lock or advanced permission to open;

21. Voltage requirements: use single-phase AC220V. or three-phase AC380V

22. Air pressure requirements: 0.4Mpa-0.6Mpa

Work shop

Our Service

1.Pre-consultation: provides professional SMT solutions for the full line.
2.Factory Warranty: One-year warranty factory service.
3.Installation: On-site installation and commissioning, to ensure smooth production.
4. Technical Training: provides professional training from Level 1 to Level 3.
5.Technical support:provides 7 * 24 technical support.
6.Software Upgrade: offers lifetime free software upgrades for all products.

equipment.

Certification

Packing

Contact Us

SMT PCB Handling Equipment Buffer

LED Tube PCB Handling Equipment Buffer

SMT PCB handling equipment Buffer Conveyor For 1.2M LED Tube Cooling Images